Electrical Installation and Commissioning of Power Plants

Electrical Installation and Commissioning of Power Plants

  • Installation of power electrical equipment for substations, converters, and distribution devices up to 10 kV.
  • Installation of networked control systems (NCS), installation of switchgear up to 10 kV, protection and automation of the process of measurements and signaling of substations.
  • Electrical installations in hazardous and non-hazardous areas.
  • Installation of internal and external power supply networks.
  • Installation of internal and outdoor electric lighting including architectural lighting.
  • Setup grounding devices and installation of lightning protection.
  • Measure and test parameters for electrical installations.
  • Electrical repairs and replacements, eliminations of faults in electrical networks, and setup of protective and metering devices.
  • Device for an additional potential equalization system.
  • We have a registered electrical laboratory for the diagnostics of electrical equipment, measurements, and testing of cable lines. It is also used to perform:
  • Resistance measurement of grounding devices and insulation installations.
  • Checking phase-zero circuits, continuity of protective conductors, operation of the residual-current device (RCD), and operation of automatic switches and relay protection devices.
 

We support obtaining compliance certificates for the start-up of electrical installations by inspecting and aligning design and as-built documentation.